In the meantime, if you have another Mac with an optical drive and a FireWire port, you could use Target Disk Mode to allow your DLSD to access the optical drive on the other Mac, and install Leopard that way. You'll find that eBay and shopgoodwill are good sources from which to acquire parts and/or whole machines, working or otherwise. The speakers are relatively easy to replace. No amount of tightening screws will fix that, and again, these things are bound to happen. It could also be that the speaker has just begun to deteriorate anyway, from being in a humid environment or simply because it had some defect that made it not last as long as the other one. It could be that that's what happened, and the speaker has begun to deteriorate because of it. It just goes with the territory of trying to keep these old machines useful.Īs for the speaker, on your DLSD the speakers sit underneath grilles that allow spills to reach them. The latter is probably a good idea anyway, because more stuff on your DLSD is likely to fail. You probably just need to replace it, either with another working (though not necessarily newer) unit, or maybe buy one or more busted "for parts" PowerBooks that you can keep around to source spare parts from. Your DLSD is about 16 years old now, and laptop optical drives are notoriously fragile. Unfortunately, sometimes stuff just wears out. John, congratulations on acquiring a very sought-after PowerBook! The DLSD can boot via USB, but I would like to also have a dvd drive, if anyone could give me some insight I would greatly appreciate it.Īlso, the left speaker vibrates (I don't know what could cause it since I tightened the For 8 screws (also without damaging.), don't know why. I gave up and opened it again and took the dvd from the Super Drive itself, when I opened it didn't seem cracked or damaged in any way (the PB was in very great condition (the owner even gave me the box with the original wrappings.) save the Thermal paste which was completely dry, also the battery doesn't seem too well, even after a PRAM reset), I took the dvd, clean what I could with a artistic brush (without forcing or damaging anything) and tried to see if the Ejector arm of the SD was rigid, it was but it could move OK, reassembled everything and tried inserting the dvd again, the SD "sucked" the dvd as it did before but I got the same ressult. As the title implies, I have a dlsd PB which I recently acquired and revamped (re-apply thermal paste in it's three chips, replaced the HDD for a SSD and soon I'll max it ram-wise), I had a Leopard DVD and tried to boot it via Command+Option and it didn't see it in the multi-boot screen, so I then tried to make it eject the dvd, but to no sucess, then I tried resetting PRAM via the keyboard combination, left mouse click, eject key and then Open Firmware, which I also used to reset pram and the like with OF's commands, then I tried to eject it via OF, it didn't but it gave me this message:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |